Disable or re-enable the DHCP
server feature from the web user
interface
By default, your mobile hotspot acts as a DHCP server. The server assigns IP, DNS server,
and default gateway addresses to all computers connected to the LAN. The assigned
default gateway address is the LAN address of the router.
You can use another device on your network as the DHCP server, or specify the network
settings of all your computers.
To disable or re-enable the DHCP server feature from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Mobile
Router Setup.
The Mobile Router Setup page displays.
2. Clear the Use mobile router as DHCP server check box to disable the DHCP server
feature, or select the check box to re-enable it.
3. Click or tap Apply.
A message displays telling you that to save this change, your device must restart.
4. Click or tap Continue.
Your settings are saved.
Change tethering settings from the
web user interface
By default, tethering is enabled on your hotspot, and it continues broadcasting WiFi
when tethering is used. You can change these settings from the web user interface.
To change tethering settings from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Mobile
Router Setup.
The Mobile Router Setup page displays.
2. In the TETHERING section, select the Turn off WiFi when tethering check box to
disable WiFi broadcasting when tethered, or clear it to enable WiFi broadcasting
when tethered.
User Manual68Access the web user interface
Nighthawk M7 Pro
To Next Page
Loading...
