NETGEAR Nighthawk M7 Pro - Change USB Tethering Settings

NOTE: Most carriers issue a private wireless wide area network (WWAN) IP
address to your device. Some carriers have special plans that issue a public
WWAN IP, or can add a public WWAN IP to your existing plan for an additional
charge. Contact your carrier for more information if your situation requires a
public WWAN IP address.
To enable or disable IP passthrough:
1. Quickly press and release the Power button to wake your mobile hotspot.
The lock screen displays.
2. Swipe up to unlock your mobile hotspot.
The home screen displays.
3. Tap Settings > More > IP Passthrough.
The IP Passthrough page displays.
4. Tap the ON or OFF icon.
Your mobile hotspot asks you to confirm that it must restart to enable or disable IP
passthrough.
5. Tap Continue.
Your mobile hotspot restarts with IP passthrough enabled or disabled.
Change USB tethering settings
By default, your mobile hotspot has USB tethering enabled so that you can connect
computers to the Internet with a USB cable instead of WiFi or Ethernet. You can optionally
disable USB tethering entirely, or restrict Internet connections exclusively to USB
tethering.
To change USB tethering settings:
1. Quickly press and release the Power button to wake your mobile hotspot.
The lock screen displays.
2. Swipe up to unlock your mobile hotspot.
The home screen displays.
3. Tap Settings > More > USB Tethering.
The USB Tethering page displays.
4. Select the USB tethering options:
User Manual49Adjust network, security, and
performance settings
Nighthawk M7 Pro