The Other page displays.
2. In the DMZ section, select the Enable check box.
3. In the DMZ Address field, enter the IP address of the computer to which you want
all data sent.
If your mobile hotspot is tethered using a USB cable, this address is 192.168.1.4. If
your mobile hotspot is connected using WiFi, the first WiFi client’s IP address is
usually 192.168.1.XX. You can check connected device IP addresses from the mobile
hotspot Connected Devices on page 27 or Network Map on page 28 pages.
NOTE: IPv6 addresses are not supported.
4. Click or tap Apply.
Your settings are saved.
User Manual78Access the web user interface
Nighthawk M7 Pro
To Next Page
Loading...
