EasyManuals Logo

NETGEAR ProSafe WNAP320 User Manual

NETGEAR ProSafe WNAP320
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
Chapter 5. Advanced Configuration | 87
ProSafe Wireless-N Access Point WNAP320 Reference Manual
g. Click Apply to save your security profile settings. The Bridging screen displays
again.
h. I
f the correct profile name and security option are displayed in the table, select the
check box in the Enable column.
i. Click Apply in th
e Bridging screen to save your point-to-point bridge settings.
2. Conf
igure a second wireless access point (AP2) on LAN Segment 2 (see Figure 51 on
page 85) in point-to-point bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field, and AP2 must
h
ave AP1’s MAC address in its Remote MAC Address field.
Authentication Settings
Network Authentication
and
Data Encryption
From the Network Authentication drop-down list, select Open System,
WPA-PSK, or WPA2-PSK. Your selection determines the options that the
Data Encryption drop-down list provides, and whether or not the WPA
Passphrase (Network Key) field displays.
Open System Although you can use the bridge communication without any
au
thentication and encryption, NETGEAR recommends that
you use WEP if you do select an open system. From the
Data Encryption drop-down list, select one of the following:
None. No authen
tication and encryption.
64-bit WEP. Standard WEP encryption, using 40/64-bit
encryption.
128-b
it WEP. Standard WEP encryption, using 104/128-bit
encryption.
15
2-bit WEP. Proprietary WEP encryption mode, using
128+24 bits encryption. This mode functions only with
other wireless station that support this mode.
WPA-PSK TKIP (T
emporal Key Integrity Protocol) is the standard
encryption method used with WPA-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Netw
ork Key) field, enter a
passphrase. The passphrase length must be between 8 and
63 characters (inclusive).
WPA2-PSK AES (Advance
d Encryption Standard) is the standard
encryption method used with WPA2-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Netw
ork Key) field, enter a
passphrase. The passphrase length must be between 8 and
63 characters (inclusive).
Note: NETGEAR recommends WPA2-PSK authentication
wi
th AES encryption if you want to use the 11n rates and
speed.
Table 25. Point-to-Point Bridge Profile and Authentication Settings (Continued)
Field Description

Table of Contents

Other manuals for NETGEAR ProSafe WNAP320

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSafe WNAP320 and is the answer not in the manual?

NETGEAR ProSafe WNAP320 Specifications

General IconGeneral
BrandNETGEAR
ModelProSafe WNAP320
CategoryWireless Access Point
LanguageEnglish

Related product manuals