Specify Network Settings
122
Nighthawk AC1900 Smart WiFi Router
The BASIC Home page displays.
4. Select ADV
ANCED > Setup > LAN Setup.
5. In the IP Address field, type the IP address.
6. In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identifies which addresses are local to a specific device
and which must be reached through a gateway or router.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with
other routers.
a. In the RIP Direction list, select one of the following:
- Both.
The router broadcasts its routing table periodically and incorporates
information that it receives.
- Out Only.
The router broadcasts its routing table periodically.
- In Only.
The router incorporates the RIP information that it receives.
b. In the RIP Version list, select one of the following:
- Disabled.
This is the default setting.
- RIP-1.
This format is universally supported. It is adequate for most networks,
unless you have an unusual network setup.
- RIP-2.
This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
multicasting.
8. Click the Apply button.
Your changes are saved.
If you changed the LAN IP address of the router, you are disconnected when this change
takes ef
fect.
9. To reconnect, close your browser, relaunch it, and log in to the router
To Next Page
Loading...
Need help?
General
