EasyManuals Logo

NETGEAR R7000 User Manual

NETGEAR R7000
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
Troubleshooting
185
Nighthawk AC1900 Smart WiFi Router
LEDs Never Turn Off
When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the
LEDs stay on, this indicates a fault within the router.
If all LEDs are still lit one minute after power-up, do the following:
Cycle the power to see if the router recovers.
Press and hold the Reset button to return the router to its factory settings. For more
information, see
Troubleshoot Your Network Using the Ping Utility on page 189.
If the error persists, you might have a hardware problem. Contact technical support at
www.netgear.com/support.
Internet or Ethernet Port LEDs Are Off
If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet
connection is made, check the following:
Make sure that the Ethernet cable connections are secure at the router and at the modem
or computer.
Make sure that power is turned on to the connected modem or computer.
Be sure that you are using the correct cable.
When connecting the router’s Internet port to a cable or DSL modem, use the cable that
was supplied with the cable or DSL modem. This cable can be a standard
straight-through Ethernet cable or an Ethernet crossover cable.
WiFi LED Is Off
If the WiFi LED stays off, check to see if the WiFi On/Off button on the router has been
pressed. This button turns the wireless radios in the router on and off. The WiFi LED is lit
when the wireless radio is turned on.
Cannot Log In to the Router
If you are unable to log in to the router from a computer on your local network, check the
following:
If you are using an Ethernet-connected computer, check the Ethernet connection
between the computer and the router.
Make sure that the IP address of your computer is on the same subnet as the router. If
you are using the recommended addressing scheme, your computer’s address is in the
range of 192.168.1.2 to 192.168.1.254.
If your computer’s IP address is shown as 169.254.x.x, recent versions of Windows and
Mac OS generate and assign an IP address if the computer cannot reach a DHCP server.
These autogenerated addresses are in the range of 169.254.x.x. If your IP address is in

Table of Contents

Other manuals for NETGEAR R7000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR R7000 and is the answer not in the manual?

NETGEAR R7000 Specifications

General IconGeneral
BrandNETGEAR
ModelR7000
WiFi Technology802.11ac
USB Ports1 x USB 3.0, 1 x USB 2.0
Antennas3 external antennas
BeamformingYes
RAM256 MB
Flash Memory128 MB
Frequency Band2.4 GHz / 5 GHz
WiFi SpeedUp to 1900 Mbps
Processor1 GHz dual-core processor
Ethernet Ports5 (1 WAN & 4 LAN)
SecurityWPA/WPA2
Dimensions285 x 184.5 x 50 mm (11.22 x 7.26 x 1.97 in)
Weight750 g

Related product manuals