Specify Internet Port Settings
179
Nighthawk AC1900 Smart WiFi Router
4. Select ADVANCED > Advanced Setup > Port Forwarding/Port Triggering.
5. Select the Port T
riggering radio button.
6. Click the Add Service button.
7. In the Service Name field, type a descriptive service name.
8. In the Service User list, select Any
, or select Single address and enter the IP address of
one computer:
• Any (the default) allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer
.
9. Select the service type, either TCP or UDP or TCP/UDP (both).
If you are not sure, select TCP/UDP.
10. In the T
riggering Port field, enter the number of the outbound traffic port that will open the
inbound ports.
11. Enter the inbound connection port information in the Connection T
ype, Starting Port, and
Ending Port fields.
12. Click the Apply button.
The service is now in the Portmap table. You must enable port triggering before the router
used port triggering for the service that you added. See the following section.
Enable Port Triggering
To enable port triggering:
1. Launch a web browser from a computer or WiFi device that is connected to the network.
2. Enter http://www
.routerlogin.net.
A login window displays.
3. Enter the router user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
To Next Page
Loading...
Need help?
General
