Specify Network Settings
138
Nighthawk AC1900 Smart WiFi Router
• Get dynamically from existing router. The other router on the network assigns an
IP address to this router while this router is in AP mode.
• Enable fixed IP settings on this device (not recommended). Use this setting if you
want to manually assign a specific IP address to this router while it is in
AP mode.
Using this option effectively requires advanced network experience.
Note: To avoid interference with other routers or gateways in your network,
NETGEAR recommends that you use different wireless settings on
each router. You can also turn off the wireless radio on the other router
or gateway and use the R7000 only for wireless client access.
8. Click the Apply button.
The IP address of the router changes, and you are disconnected.
9. T
o reconnect, close and restart your browser and enter http://wwwrouterlogin.net.
Set Up the Router in Bridge Mode
You can use your router in bridge mode to connect multiple devices wirelessly at the faster
802.11ac speed. You need two routers: one set up as a router and the other set up as a
bridge.
Smart WiFi Router in bridge mode
Smart WiFi Router
Figure 12. Router in bridge mode with an 802.11ac WiFi connection
Installing your R7000 as a bridge offers the following benefits:
• T
ake advantage of gigabit WiFi speeds on current devices.
• Use Gigabit WiFi for applications like video and gaming.
To Next Page
Loading...
Need help?
General
