NETGEAR ReadyNAS 3220

Note: Depending on the system's last power state, the system might power on
automatically. For more information, see Power State on page 16.
3.
If necessary, press the Power button on the front panel of the system.
The system powers on.
Preferred Shutdown
You can gracefully shut down your system by using the Power button or the ReadyNAS
local admin page.
For information about how to gracefully shut down your system using the ReadyNAS
local admin page, see the ReadyNAS OS 6.5 Software Manual, which is available at
http://support.netgear.com/product/ReadyNAS-OS6.
To gracefully shut down your system using the Power button:
1.
Press the Power button on the front panel of the system.
The Power LED blinks, prompting you to confirm the shutdown.
2. Press the Power button again.
The system shuts down gracefully.
Forced Shutdown
Perform a forced shutdown only if the storage system is not responding.
To perform a forced shutdown:
• Flip the Power switch to the Off position.
The Power switch is located on the back panel of the system.
The system shuts down.
Power State
If the power supply is interrupted due to a power failure, the system returns to its last
state once the power supply is restored, as follows:
•
If the system was powered on at the time of the power failure, the system powers
on when the power supply is restored.
•
If the system was powered off at the time of the power failure, the system remains
off when the power supply is restored.
Hardware Manual16ReadyNAS 2120 and 2120 v2
ReadyNAS OS 6