Rack-Mount Setup
Use the rack-mount hardware included with your ReadyNAS 3312, 3312 v2, 4312X,
4312X v2, 4312S, or 4312S v2 storage system to install it in a rack. Read Rack-Mount
Precautions on page 126.
Danger: A system with installed drives can weigh more than 80 pounds. To avoid injury
or damage to the equipment, perform the rack-mount installation with appropriate
assistance.
Installation
Read these instructions in their entirety before you begin. Locate the shipping carton,
remove the rack-mounting kit, and prepare to work with it.
The rack-mounting kit contains two rail assemblies. Each assembly consists of two
sections:
•
An inner fixed chassis rail that secures directly to the system’s chassis
•
An outer fixed rack rail that secures directly to the rack itself
To install the system into a rack:
1. Extend the rail assembly by pulling it outward.
2.
Press the release tab and separate the inner rail from the outer assembly.
Hardware Manual70ReadyNAS 3312, 3312 v2, 4312,
and 4312 v2
ReadyNAS OS 6
To Next Page
Loading...
