NETGEAR ReadyNAS 3220

The system powers on.
4.
Continue to press the Reset button for about five seconds until the Power LED is
solid green and the Error LED, LAN 1 LED, and LAN 2 LED are blinking.
5. Press and release the Reset button to scroll through the boot mode menu.
Each press and release scrolls forward to the next item in the boot mode menu.
The storage system shows the boot mode options using the LEDs, as described in
the following table:
Status IndicatorBoot Mode
Power
LED
LAN 2
LED
LAN 1
LED
Error
LED
Description
Error LED and both LAN LEDs blink. Power
LED lights.
Boot menu
LAN 2 and Power LEDs light.Normal
LAN 1 and Power LEDs light.Factory default
Both LAN LEDs and the Power LED light.OS reinstall
Error and Power LEDs light.Tech support
Error, LAN 2, and Power LEDs light.Volume read only
Error, LAN 1, and Power LEDs light.Memory test
All four LEDs light.Test disk
Legend:
•
Solid:
•
Blinking:
•
Off:
6.
Press and hold the Reset button for five seconds to confirm your boot menu selection.
The system boots in the selected boot mode.
Hardware Manual18ReadyNAS 2120 and 2120 v2
ReadyNAS OS 6