NETGEAR ReadyNAS 3220

Table 6. Front panel status indicators
DescriptionIndicator
The Power LED indicates these states:
•
Solid blue. The system is powered on.
•
Off. The system is powered off.
•
Blinking blue. The system is entering boot mode.
Power LED
The Health LED indicates these states:
•
Solid red. The system needs attention. Use the local admin page to determine
the problem. For more information, see the ReadyNAS OS 6.5 Software Manual,
which is available at support.netgear.com/product/ReadyNAS-OS6.
•
Off. The system is healthy.
•
Blinking red. The system is entering boot mode.
Health LED
The 10GbE LED indicates these states:
•
Green. An Ethernet cable is connected.
•
Blinking green. The Ethernet link is active.
•
Off. The system did not detect an Ethernet connection.
10GbE LED
The GbE LEDs indicate these states:
•
Green. An Ethernet cable is connected.
•
Blinking green. The Ethernet link is active.
•
Off. The system did not detect an Ethernet connection.
GbE LED
The top LED is the Disk Drive Power LED, which indicates the disk status as follows:
•
Blue. A disk is present.
•
Off. No disk is present.
The bottom LED is the bicolor Disk Drive Activity and Fault LED, which indicates
disk activity and boot mode as follows:
•
Blinking green. The disk is active.
•
Off. No disk activity is detected.
•
Solid red. The disk failed or is faulty.
•
Solid red for all disks. The system entered boot mode.
•
Solid red for disks 1 through 7. Indicates the boot mode option. (For infomration
about disk numbering, see Front Panel on page 59.)
Disk LEDs (disk trays)
Hardware Manual64ReadyNAS 3312, 3312 v2, 4312,
and 4312 v2
ReadyNAS OS 6