3.
Press the Power button on the front panel of the system.
The system powers on.
4. Continue to press the Reset button until the Power and Health LEDs are blinking
and all Disk Drive Activity and Fault LEDs are solid red.
Note: It takes approximately one minute for the system to enter boot mode.
5. Press and release the Reset button to scroll through the boot menu modes.
The storage system shows the boot mode options using the Power LED, Health LED,
and the Disk Drive Activity and Fault LEDs (A&F LEDs) for disks 1 through 7 (for
information about LEDs and disk numbering, see Front Panel on page 59), as
described in the following table:
Status IndicatorsBoot
Mode
Disk Drive Activity and Fault LEDsHealth
LED
Power
LED
Description
Disk
7
Disk
6
Disk
5
Disk
4
Disk
3
Disk
2
Disk
1
Power and Health LEDs
blink and all A&F LEDs are
solid red.
Boot
menu
A&F LED disk 1 is solid red.Normal
A&F LEDs disks 1 and 2 are
solid red.
Factory
default
A&F LEDs disks 1 through
3 are solid red.
OS
reinstall
A&F LEDs disks 1 through
4 are solid red.
Tech
support
A&F LEDs disks 1 through
5 are solid red.
Volume
read only
Hardware Manual68ReadyNAS 3312, 3312 v2, 4312,
and 4312 v2
ReadyNAS OS 6
To Next Page
Loading...
