3.
Press the Power button on the front panel of the system.
The system powers on.
4. Continue to press the Reset button until LEDs 1, 2, and 3 are blinking.
Note: It takes approximately one minute for the system to enter boot mode.
5. Press and release the Reset button to scroll through the boot menu modes.
Status IndicatorsBoot Mode
LED 3LED 2LED 1
Boot menu
Normal
Factory default
OS reinstall
Tech support
Volume read only
Memory test
Test disk
Legend:
Solid:
Blinking:
Off:
6.
Press and hold the Reset button to confirm your boot menu selection.
The system boots in the selected boot mode.
Hardware Manual76ReadyNAS 4360
ReadyNAS OS 6
To Next Page
Loading...
