For information about enabling neighbor AP detection, see Enable neighbor access
point detection and move access points to the Known AP List on page 121.
To import a list with MAC addresses of known neighbor access points in the Known
AP List:
1.
Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > Security > Neighbor AP.
The page that displays lets you select the radio band (2.4GHz or 5GHz).
User Manual124Manage Access and Security
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
