NETGEAR WAC510 - Router Mode: Enable the DHCP Client and Let the Access Point Obtain a WAN IP Address

4.
Select Management > Configuration > IP > LAN.
5. Select the Enable radio button.
The fields are masked.
6. Click the Apply button.
Your settings are saved. The access point restarts with the new IP settings. It might
take a while before the access point receives its IP address setting from the DHCP
server.
Router mode: Enable the DHCP client and let the access
point obtain a WAN IP address
If your Internet service provider (ISP) assigns IP addresses automatically through their
DHCP server and you enable the DHCP client of the access point if the access point
functions in Router mode, the access point can automatically obtain an IP address from
your ISP. (This is the default setting if the access point functions in Router mode.)
To enable the DHCP client if the access point functions in Router mode:
1.
Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
User Manual136Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual