NETGEAR WAC510

6
Manage the Local Area Network
and IP Settings
This chapter describes how you can manage the local area network (LAN) and IP settings
of the access point.
The chapter includes the following sections:
• Disable the DHCP client and configure a LAN or WAN IP address
• Enable the DHCP client
• Set the 802.1Q VLAN and management VLAN
• AP mode only: Specify an existing domain name
• Enable or disable Spanning Tree Protocol
• Enable or disable the network integrity check function
• Enable or disable IGMP snooping
• Enable or disable Ethernet LLDP
• Enable or disable UPnP
• Router mode only: Manage DHCP servers
128