5.
From the WAN Interface Type menu, select Static.
The page also displays the WAN Interface field, which is fixed at WAN (Ethernet
Port).
6.
Specify the settings that are described in the following table.
DescriptionSetting
IP address in the range that is used by your Internet modem.IP Address
The subnet mask must be compatible with your Internet modem. (The subnet mask
is usually 255.255.255.0.)
Subnet Mask
IP address of the gateway that is used by your Internet modem.Gateway
IP address of the primary DNS server that is used by your Internet modem.Primary DNS
IP address of the secondary DNS server that is used by your Internet modem, or leave
this field blank.
Secondary DNS
7. Click the Apply button.
Your settings are saved. The access point restarts with the new IP settings and
establishes a connection with your ISP. This process might take a while.
Router mode: Specify WAN Point-to-Point Protocol over
Ethernet settings
To configure a WAN Point-to-Point Protocol over Ethernet (PPPoE) connection, you
need the PPPoE login information that your Internet service provider (ISP) gave you
when you signed up for the Internet service.
User Manual132Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
