4.
Select Management > Configuration > Wireless > Advanced > Load Balancing.
5.
To enable load balancing for the radios, select the Load Balancing Mode Enable
radio button.
By default, load balancing is disabled.
The page provides a slider for each radio.
6.
For each radio, move the associated slider to specify the percentage of network
bandwidth utilization that is allowed on the radio before it stops accepting new client
associations.
The default is 90%, which specifies that all new associations are allowed up to 90
percent of the utilization rate of the radio.
7. Click the Apply button.
A pop-up warning window opens.
8. Click the OK button.
The pop-up window closes and your settings are saved. The radio or radios restart
and WiFi clients might need to reconnect.
Set a data volume limit for the access point
You can set a total monthly data volume limit that applies to all WiFi networks that you
configure on the access point, that is, it applies to all SSIDs (or VAPs) collectively. A
typical use of this feature is to restrict guest user data consumption.
User Manual98Manage the Advanced WiFi and
Radio Features
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
