Factory default settings
You can reset the access point to the factory default settings, which are shown in the
following table.
For more information about resetting the access point to its factory settings, see Return
the access point to its factory default settings on page 181.
Table 3. Factory default settings
Default SettingFeature
Management and login settings
NETGEAR Insight management modeManagement mode
192.168.0.100User login URL
admin, nonconfigurableUser name (case-sensitive)
password, configurableLogin password
(case-sensitive)
General system settings
AP mode
By default, Router mode is disabled, including NAT and the DHCP server function.
Operating mode
Enabled so that the access point receives an IP address from a DHCP server or router
in the network.
DHCP client
EnabledNTP client
DisabledSpanning Tree Protocol
DisabledNetwork integrity check
Untagged VLAN with VLAN ID 1802.1Q VLAN
VLAN ID 1Management VLAN
DisabledSyslog
EnabledEthernet LLDP
EnabledUPnP
EnabledLEDs
WiFi network settings for initial setup
SSID for initial setup is NETGEARxxxxxx-SETUP, where xxxxxx is the last six hexadecimal
digits of the access point’s MAC address.
SSID name
User Manual228Factory Default Settings and
Technical Specifications
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
