If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > System > Basic.
The General page displays the basic system settings.
5.
Select a country or region from the Country / Region menu.
6. Click the Apply button.
A pop-up warning window opens.
7. Click the OK button.
The pop-up window closes and your settings are saved. The access point restarts
with the default WiFi settings that are specific to the selected country or region.
Change the admin user account password
This admin user account password is the password that you must use to log in to the
local browser interface of the access point with the user name admin. (It is not the
passphrase that you use for WiFi access.)
The password must be 8 to 63 characters in length and must contain at least one
uppercase letter, one lowercase letter, and one number. The following special characters
are allowed:
! @ # $ % ^ & * ( )
To change the password for the user name admin:
1.
Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
User Manual164Manage and Maintain the Access
Point
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
