If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > IP > WAN.
The page that displays lets you specify the WAN settings.
5.
From the WAN Interface Type menu, select Dynamic.
Note: All fields are automatically populated when the access point obtains an IP
address from your Internet service provider (ISP). That is, the ISP assigns the IP
address and all other all related settings. However, the WAN Interface field is fixed
at WAN (Ethernet Port).
6. Click the Apply button.
Your settings are saved. The access point restarts with the new IP settings, establishes
a connection with the ISP, and obtains a WAN IP address from the DHCP server of
your ISP. This process might take a while.
User Manual137Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
