NETGEAR WAC510 - Page 130

If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > IP > LAN.
The page that displays lets you specify the LAN settings, but the fields are masked
because the DHCP client is enabled.
5. Select the Disable radio button.
6.
Specify the settings that are described in the following table.
DescriptionSetting
IP address in the range that is used by your LAN.IP Address
The subnet mask must be compatible with your LAN. (The subnet mask is usually
255.255.255.0).
Subnet Mask
IP address of the gateway on your LAN.Gateway
IP address of the primary Domain Name System (DNS) server on your LAN.Primary DNS
IP address of the secondary DNS server on your LAN, or leave this field blank.Secondary DNS
7. Click the Apply button.
Your settings are saved. The access point restarts with the new IP settings.
User Manual130Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual