NETGEAR WAC510 - Page 134

6.
Specify the settings that are described in the following table.
DescriptionSetting
The user name that your ISP gave you for the PPPoE connection or that you
personalized.
User Name
The password that your ISP gave you for the PPPoE connection or that you
personalized.
Password
From the Connection Mode menu, select one of the following options:
•
Automatic. After you click the Apply button, the access point automatically
establishes a PPPoE connection with the ISP.
•
Manual. After you click the Apply button, you must manually establish the PPPoE
connection with the ISP by clicking the Connect button.
When the connection is established, to terminate the PPPoE connection, you must
click the Disconnect button.
Connection Mode
Note: Whether you select the automatic or manual connection mode, all other fields
are automatically populated when the access point obtains an IP address from your
ISP. That is, the ISP assigns the IP address and all other all related PPPoE settings.
However, the WAN Interface field is fixed at WAN (Ethernet Port).
7. Click the Apply button.
Your settings are saved.
If you specified an automatic connection mode, the access point establishes a PPPoE
connection with the ISP, obtains a WAN IP address from the ISP.
8.
If you specified a manual connection mode, click the Connect button.
The access point establishes a PPPoE connection with the ISP and obtains a WAN
IP address from the ISP. This process It might take a while.
After the access point obtains a WAN IP address, the Connect button changes to
the Disconnect button to enable you to manually terminate the PPPoE connection.
User Manual134Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual