3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > IP > LAN > DHCP Server Settings.
If you did not yet add any DHCP servers, only + Add Server displays.
5.
Click the + button to the left of Add Server.
Servers that you add are designated Server 2 through Server 7.
By default, the Enable radio button is selected.
6.
Specify the settings that are described in the following table.
DescriptionSetting
From the VLAN ID menu, select the VLAN ID for the WiFi network (SSID) to which
you assign the DHCP server. For information about assigning a VLAN ID to a WiFi
network, see Change the VLAN ID for a WiFi network on page 58.
VLAN ID
Enter the starting IP address of the DHCP IP address range.Starting Address
User Manual152Manage the Local Area Network
and IP Settings
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
