To specify a custom NTP server:
1.
Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > System > Basic > Time.
By default, the Enable radio button is selected and the access point receives its time
from a default NETGEAR NTP server.
5. Select the Use Custom NTP Server check box.
6.
Take one of the following actions:
•
Enter the host name of the NTP server.
By default, the Hostname radio button is selected.
•
Select the IP address radio button and enter the IP address of the NTP server.
7. Click the Apply button.
User Manual167Manage and Maintain the Access
Point
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
