The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4. Select Management > Diagnostics > Ping Test.
5.
Specify the settings that are described in the following table.
DescriptionSetting
The number of pings that the access point must send. The default number is 16.Ping Count
The size of each ping packet. The default size is 64 bytes.Packet Size (in Bytes)
The interval between pings. The default interval is 1 second.Ping Interval (in sec)
The period after which a ping times out. The default period is 60 seconds.Ping Timeout (in sec)
The IP address that the access point must ping.Remote Host
6. To start the ping test, click the Start button.
The results of the ping test display in the Ping Result field.
7.
To stop the ping test before the ping count is reached or if the ping times out, click
the Stop button.
User Manual215Diagnostics and
Troubleshooting
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
