11.
Configure the client isolation and URL tracking settings as described in the following
table.
DescriptionSetting
By default, client isolation is disabled for the VAP. To block communication between
WiFi clients that are associated with the same SSID or different SSIDs on the access
point, select the Enable radio button.
If you want to enable client isolation for an SSID and the access point functions in
Router Mode, you must disable inter-VLAN routing for the VLAN that is associated
with the SSID (see Enable or disable inter-VLAN routing on page 157).
Client Isolation
By default, URL tracking is disabled, and the Disable radio button is selected. To
enable URL tracking for all URLs that are requested by WiFi clients that are connected
to the SSID, select the Enable radio button.
For information about how to view the tracked URLs per SSID or per WiFi client, see
View or download tracked URLs on page 203.
URL Tracking
Although you could also configure a captive portal, a MAC ACL, and bandwidth rate
limits while you set up a WiFi network, these features are described separately and
in detail in the following sections:
•
Set up and manage captive portals for WiFi networks on page 64
•
Manage local MAC access control lists on page 110 and Select a MAC ACL for a
WiFi network on page 61
•
Set bandwidth rate limits for a WiFi network on page 63
12. Click the Apply button.
Your settings are saved.
User Manual50Manage the Basic WiFi and
Radio Features
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
To Next Page
Loading...
