NETGEAR WAC510 - Page 62

enable the MAC ACL. Only WiFi devices that are in the selected access list can connect
to the SSID.
To select a MAC ACL for a WiFi network:
1.
Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Select Management > Configuration > Wireless > Basic.
The page that displays lets you select an SSID.
5.
Click the > button to the left the SSID.
The settings for the selected SSID display.
6. Click the > Advanced tab.
The page expands.
7. Select the MAC ACL check box.
8.
Do one of the following:
•
Select the Local MAC ACL radio button, and from the Select Group menu, select
the MAC ACL that you defined earlier.
To change the MAC ACL policy, MAC addresses in the ACL, or both, click the
link next to the group. For more information, see Manage local MAC access
control lists on page 110.
•
Select the Radius MAC ACL radio button.
User Manual62Manage the Basic WiFi and
Radio Features
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual