Security
119
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
• HTTPS Authentication List
HTTP Authentication List
Use the HTTP Authentication List screen to configure the default HTTP login list.
To change the HTTP authentication method for the default list:
1. Select Security > Management Security > Authentication List > HTTP Authentication
List.
2. Select the check box next to the List Name.
3. From the list in the 1 column, select the HTTP authentication method that must appear first
in the selected authentication login list.
If you select a method that does not time out as the first method, such as local, no other
method is attempted, even if you have specified more than one method. This parameter
does not appear when you first create a login list. User authentication occurs in the order
the methods are selected. Possible methods are as follows:
• Local. The user's locally stored ID and password is used for authentication. Since the
local method does not time out, if you select this option as the first method, no other
method is tried, even if you have specified more than one method.
• None. The authentication method is unspecified. This option is available only for
method 2 and method 3.
• RADIUS. The user's ID and password is authenticated using the RADIUS server. If
you select RADIUS or TACACS+ as the first method and an error occurs during the
authentication, the switch uses method 2 to authenticate the user.
• TACACS+. The user's ID and password is authenticated using the TACACS+ server.
If you select RADIUS or TACACS+ as the first method and an error occurs during the
authentication, the switch attempts user authentication method 2.
Note: Each authentication protocol can use up to three authentication
methods. Local and None must be the last methods. You cannot
configure methods after these two options.
4. From the list in the 2 column, select the authentication method, if any, that must appear
second in the selected authentication login list.
This method will be used if the first method times out.
If you select a method that does not time out as the second method, the third method is
not tried. This parameter does not appear when you first create a login list.
5. From the list in the 3 column, select the authentication method, if any, that must appear third
in the selected authentication login list.
This parameter does not appear when you first create a login list.
6. Click Apply to update the switch with the HTTP Authentication settings.
To Next Page
Loading...
