NETGEAR XS728T ProSAFE - Switch Features and Defaults

Hardware Specifications and Default Values
182
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
Switch Features and Defaults
Feature Sets Supported Default
Auto negotiation/static
speed/duplex
All ports Auto-negotiation
Auto MDI/MDIX N/A Enabled
802.3x flow control/back pressure 1 (per system) Disabled
Port mirroring 1 destination port and 8 source
ports
Disabled
Port trunking (aggregation) 8 Pre-configured
802.1D spanning tree 1 Disabled
802.1w RSTP 1 Enabled
802.1s spanning tree 16 instances Disabled
Static 802.1Q tagging 512 Default VLAN ID = 1
Learning process Supports static and dynamic MAC
entries
Dynamic learning is enabled by
default
Storm control per each packet
type (unicast, broadcast,
multicast)
All ports Disabled
Jumbo frame All ports Enabled.
Max.= 10 KB
Number of queues 8 N/A
Port based N/A N/A
802.1p 1 Enabled
DSCP 1 Disabled
Rate limiting All ports Disabled
Auto-QoS All ports Disabled
802.1x All ports Disabled
MAC ACL 164 (shared with IP and IPv6
ACLs)
All MAC addresses allowed
IP ACL 164 (shared with MAC and IPv6
ACLs)
All IP addresses allowed
IPv6 ACL 164 (shared with IP ACL and MAC
ACL)
All IP addresses allowed