NETGEAR XS728T ProSAFE - Device View; Snmp

System
29
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
• Remote Tw_sys_rx (uSec). Displays the amount of time the Remote Tw_sys_rx has
been present on the port.
• Remote Tw_sys_rx Echo (uSec). Displays the amount of time the Remote
Tw_sys_rx Echo has been present on the port.
Green Ethernet Summary
This screen summarizes the Green Ethernet Summary settings and status per interface.
 To access the Green Ethernet Summary screen:
1. Select System > Management > Green Ethernet > Green Ethernet Summary.
2. In the Green Mode Statistics Summary section, view the following:
• Cumulative Energy Saving (Watts*Hours). Displays the cumulative energy savings
on the local device.
3. In the Green Ethernet Interface Summary section, view the following:
• Interface. Lists the local interfaces on the device.
• Energy Detect Admin Mode. Displays the Energy Detect Admin mode for each of
the local interfaces (always Enabled).
• Energy Detect Operational Status. Displays the operational status of the Energy
Detect mode for each of the local interfaces (Active or Inactive).
• Short Reach Admin Mode. Displays the Short Reach Admin Mode for each of the
local interfaces (always Enabled).
• Short Reach Operational Status. Displays the operational status of the Short Reach
Admin mode for each of the local interfaces (Active or Inactive).
• EEE Admin Mode. Displays the EEE Admin mode for each of the local interfaces
(Enable or Disable).
Device View
The Device View is a Java applet that displays the ports on the switch. This graphic provides
an alternate way to navigate to configuration and monitoring options. The graphic also
provides information about device ports, current configuration and status, table information,
and feature components.
The Device View is available by selecting System > Device View.
SNMP
From SNMP menu under the System tab, you can configure SNMP settings for SNMP v1/v2
and SNMPv3.
SNMP features are described in the following sections:
• SNMP v1/v2