Security
140
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
MAC Binding Configuration
When an ACL is bound to an interface, all the rules that have been defined are applied to the
selected interface. Use the MAC Binding Configuration screen to assign MAC ACL lists to
ACL priorities and interfaces.
To configure MAC ACL interface bindings:
1. Select Security > ACL > Basic > MAC Binding Configuration.
2. From the ACL ID list, select an existing MAC ACL.
The packet filtering Direction for ACL is Inbound, which means the MAC ACL rules are
applied to traffic entering the port.
3. Specify an optional Sequence Number to indicate the order of this access list relative to
other access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If you do not specify the sequence number, a
sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used. The valid range is 1–2147483647.
4. Click the appropriate bar to expose the available ports or LAGs.
• To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that a
? appears in the box.
• To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An
? in the box indicates that the ACL is
applied to the interface.
5. Click Apply to update the switch with the new settings.
The above fields are displayed in the Interface Binding Status block for each interface. In
addition, the ACL Type (MAC, IPv4 or IPv6) is displayed.
MAC Binding Table
To view or delete the MAC ACL bindings.
1. Select Security > ACL > Basic > MAC Binding Table.
To Next Page
Loading...
