NETGEAR XS728T ProSAFE - Mac Acl; Mac Rules

Security
138
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
6. To apply the ACL to additional interfaces, selected the required ACL and add ports by
clicking the box under the interface number. Click Apply to update the switch with the new
settings.
Configuration changes take effect immediately.
MAC ACL
A MAC ACL consists of a set of rules that are matched sequentially against a packet. When a
packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken
and the additional rules are not checked for a match.
The steps for defining a MAC ACL and applying it to the switch are described in the following
sections:
1. Use the MAC ACL screen to create the ACL ID.
2. Use the MAC Rules screen to create rules for the ACL.
3. Use the MAC Binding Configuration screen to assign the ACL by its ID number to a port.
4. Optionally, use the MAC Binding Table screen to view the configurations.
 To configure a MAC ACL:
1. Select Security > ACL > Basic > MAC ACL.
2. Specify a name for the MAC ACL in the Name field. The name string can include alphabetic,
numeric, hyphen, underscore, or space characters only. The name must start with an
alphabetic character.
3. Click Add.
Each configured ACL displays the following information:
• Rules. Displays the number of rules currently configured for the MAC ACL.
• Direction. Displays the direction of packet traffic affected by the MAC ACL, which can
be Inbound or blank.
To change the name of a MAC ACL, select the check box next to the Name field, update the
name, then click Apply.
MAC Rules
Use the MAC Rules screen to define rules for MAC-based ACLs. The access list definition
includes rules that specify whether traffic matching the criteria is forwarded normally or
discarded. A default 'deny all' rule is the last rule of every list.
 To configure MAC ACL rules:
1. Select Security > ACL > Basic > MAC Rules.
2. From the ACL Name field, specify the existing MAC ACL to which the rule applies.
For information about how to set up a new MAC ACL, use the MAC ACL screen.