Routing
92
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
2. Click Update to update the page with the most current data.
ARP Entry Configuration
To add a static entry to the ARP table:
1. Select Routing > ARP > Advanced > ARP Create.
2. In the IP Address field, specify the IP address that you want to add.
It must be the IP address of a device on a subnet attached to one of the switch's existing
routing interfaces.
3. In the MAC Address field, specify the unicast MAC address of the device.
The format is six 2-digit hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
4. Click Add to add the static entry to the switch configuration.
To delete a static entry from the ARP cache, select Delete.
Entries for the switch are displayed in the Routing VLANs ARP Cache Table. This table
contains both static and dynamic addresses. Static addresses are manually configured and
do not age out. The device creates dynamic addresses from the ARP packets it receives.
Dynamic addresses age out after a configured time
Global ARP Configuration
Use the Global ARP Configuration screen to display and change the configuration
parameters of the ARP table.
To configure the global ARP settings:
1. Select Routing > ARP > Advanced > Global ARP Configuration.
2. In the Age Time field, enter the value you want the switch to use for the ARP entry ageout
time.
You must enter an integer value, which represents the number of seconds it takes for an
ARP entry to age out. The valid range is 15 – 21,600 seconds. The default value is 1200
seconds.
3. Click Apply to send the updated configuration to the switch.
Configuration changes take place immediately.
ARP Entry Management
Use this screen to remove entries from the ARP Table.
To remove entries from the ARP table:
1. Select Routing > ARP > Advanced > ARP Entry Management.
To Next Page
Loading...
