System
31
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
all valid Community Names or the set request is rejected. If you select Disable, the
Community Name becomes invalid.
3. Click Add.
Configuration changes take effect immediately.
Trap Configuration
This screen displays an entry for every active Trap Receiver.
To configure SNMP trap settings:
Select System > SNMP > SNMP v1/v2 > Trap Configuration.
To add a host that receives SNMP traps:
1. Enter trap configuration information in the following fields:
• Recipients IP. The address in x.x.x.x format to receive SNMP traps from this device.
• Version. The trap version used by the receiver.
• SNMP v1. Uses SNMP v1 to send traps to the receiver.
• SNMP v2. Uses SNMP v2 to send traps to the receiver.
• Community String. The community string for the SNMP trap packet sent to the trap
manager. This community string can be up to 16 characters and is case-sensitive.
2. Click Add.
Configuration changes take effect immediately.
To modify an existing SNMP recipient:
1. Select the check box next to the recipient, and change the desired fields.
2. Click Apply.
Configuration changes take effect immediately.
Trap Flags
Use the Trap Flags screen to enable or disable traps the switch can send to an SNMP
manager. When the condition identified by an active trap encounters the switch, a trap
message is sent to any enabled SNMP trap receivers, and a message is written to the trap
log.
To configure the trap flags:
1. Select System > SNMP > SNMP v1/v2 > Trap Flags.
2. From the All field, globally enable or disable activation of all traps by selecting the
corresponding button.
The factory default is Enable.
3. From the Authentication field, enable or disable activation of authentication failure traps by
selecting the corresponding button.
To Next Page
Loading...
