Switching
80
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
Or:
Select the interface in the Go To Interface field and click Go. The entry corresponding to
the specified interface will be selected.
4. Select the Interface Status of the interfaces. The possible values are:
• Static. The port receives all multicast streams.
• Forbidden. Interfaces cannot receive any multicast streams, even if IGMP/MLD
snooping designated the interface to join a multicast group.
• Excluded. The interface is currently not a forward all interface.
5. Click Apply to send the updated configuration to the switch.
Address Table
The Address Table contains information about unicast entries for which the switch has
forwarding or filtering information. The transparent bridging function uses this information in
determining how to propagate a received frame. Use the search function of the Address
Table screen to display information about the entries in the table.
From the Address Table link, you can access features described in the following sections:
• Address Table
• Dynamic Address
• Static MAC Address
To search for an entry in the MAC Address Table:
1. Select Switching> Address Table > Basic > Address Table.
2. In the Search By field, select whether to search for MAC addresses by MAC address, VLAN
ID, or interface.
• MAC Address: Select MAC Address and enter a 6-byte hexadecimal MAC address in
2-digit groups separated by colons, then click Go. If the address exists, that entry is
displayed. An exact match is required.
• VLAN ID: Select VLAN ID and enter the VLAN ID, for example, 100. Then click Go. If
any entries with that VLAN ID exist they are displayed.
• Interface: Select Interface, enter the interface ID in xg1, xg2... format, then, click Go.
If any entries learned on that interface exist, they are displayed.
Click Clear to clear dynamic MAC addresses in the table.
To Next Page
Loading...
