Routing
93
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
2. In the Remove From Table field, select the ARP entries to remove.
The following are ARP entries then can be removed:
• All Dynamic Entries. Remove the dynamic entries from the ARP table.
• All Static Entries. Remove the static entries from the ARP table.
• All Entries. Remove all static and dynamic entries from the ARP table.
• Specific Entry. Remove a specific ARP entry from the ARP table. If you select
Specific Entry in the Remove from Table list, you can enter the IP address of an entry
to remove from the ARP table.
• None. Select if you do not want to delete any entry from the ARP Table.
3. Click Apply to send the updated configuration to the switch.
Configuration changes take place immediately.
IPv6
The Routing> IPv6 folder contains links to the following web pages that configure and
display IPv6 routing data:
• Global Configuration
• Route Table
• VLAN Configuration
• IPv6 Addresses
• Prefix Configuration
• IPv6 Interface Statistics
• Neighbor Table
Global Configuration
Use this page to configure IPv6 routing parameters for the switch, as opposed to an
interface.
To display the IPv6 Global Configuration page, click Routing> IPv6 > Basic > Global
Configuration. The following page is displayed.
Configure IPv6 Global Configuration.
1. In the IPv6 Unicast Routing field, select the option to globally Enable or Disable IPv6
unicast routing. The default setting is Disable.
2. In the IPv6 Hop Limit field, enter a value for the unicast hop count used in IPv6 packets
originated by the node. Valid values for hops are 1 to 255, inclusive. The default is 64.
3. In the ICMPv6 Rate Limit Error Interval field, specify the interval for sending “burst size”
ICMPv6 error packets. This value controls the ICMPv6 error packets. The default Rate Limit
is 100 packets per second, meaning that the burst interval is 1000 mseconds. To disable
To Next Page
Loading...
