Configuration Examples
189
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
• Destination MAC Mask. 00:00:00:00:FF:FF
• Source MAC. 02:02:1A:BC:DE:EF
• Source MAC Mask. 00:00:00:00:FF:FF
• VLAN ID. 2
For more information about MAC ACL rules, see MAC Rules on page 150.
3. In the MAC Binding Configuration screen, assign the Sales_ACL to Ethernet ports 6, 7, and
8 and click Apply.
For more information, see MAC Binding Configuration on page 152
You can assign an optional sequence number to indicate the order of this access list
relative to other access lists if any are already assigned to this interface and direction.
4. The MAC Binding Table displays the interface and MAC ACL binding information.
For more information, see MAC Binding Table on page 152.
The ACL named Sales_ACL looks for Ethernet frames with destination and source MAC
addresses and MAC masks defined in the rule. Also, the frame must be tagged with
VLAN ID 2, which is the Sales department VLAN. The CoS value of the frame must be 0,
which is the default value for Ethernet frames. Frames that match this criteria are permitted
on interfaces 6, 7, and 8 and are assigned to the hardware egress queue 0, which is the
default queue. All other traffic is explicitly denied on these interfaces. To allow more traffic to
enter these ports, you must add a permit rule with the desired match criteria and bind the rule
to interfaces 6, 7, and 8.
Sample Standard IP ACL Configuration
The following example shows how to create an IP-based ACL that prevents any IP traffic
from the Finance department from being allowed on the ports that are associated with other
departments. Traffic from the Finance department is identified by each packet’s network IP
address.
1. In the IP ACL screen, create an IP ACL with an IP ACL ID of 1.
For more information, see IP ACL on page 153.
2. In the IP Rules screen, create a rule for IP ACL 1 with the following settings:
• Rule ID. 1
• Action. Deny
• Match Every. False
• Source IP Address. 192.168.187.0
• Source IP Mask. 0.0.0.255
For more information about IP ACL rules, see IP Rules on page 154.
3. Click Add.
4. In the IP Rules screen, create a second rule for IP ACL 1 with the following settings:
• Rule ID. 2
To Next Page
Loading...
