ZERO-n
Signal Zeroing Enable
Syntax:
ZERO-n
<state>
where
n
is either
A
or
B
Parameters:
The parameter <state>
is
a <number> which can be
0
or
1.
If
the number is
0,
then readings are not adjusted by the stored zero reference.
If
the number is
1,
then readings are adjusted by the stored zero reference.
Function:
This command enables or disables the zeroing feature. Zeroing causes the
stored zero reference
(see
STOZERO-n command) to be subtracted from
incoming signal readings before the incoming signal
is
used in measurement
calculations.
Related Commands: STOZERO-n, ZERO-n?, ZEROVAL-n
ZERO-n?
Signal Zeroing Enable Query
Syntax:
ZERO-n?
where
n
is either
A
or
B
Parameters:
None
Function:
This query returns
a
value showing whether or not zeroing is enabled or
disabled.
Returns: <state>
<state> is of type <number> and represents the integer
0,
if
zeroing
is
enabled,
or
1,
if zeroing
is
disabled.
Related Commands: STOZERO-n, ZERO-n, ZEROVAL-n
ZEROVAL-n?
Zero Signal Query
Syntax:
ZEROVAL-n?
where n
is
either
A
or
B
Parameters: None
Function:
This query returns the current value being used for zeroing.
Returns: <zeroval>
aerovab is of type <number> in exponential notation. The units
of
this value
are the numerator of the detector's responsivity, i.e. amps.
Related Commands:
STOZERO-n, ZERO-n, ZERO-n?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
