Page | 206
The entry above will ‘remember’ the current clip with the name “AAA1”. (The default for ID is an
empty string, which is a valid storage target.)
CLIP_RESTORE
This command cues up content previously stored with a specified ID value on the upstream
source channel assigned to the network input designated.
For example:
The clip previously indexed as “AAA1” (using clip_store) is restored on the source system output
channel connected to Net 1. The playhead is set to the beginning of the clip. (If the indexed clip
is not located, nothing occurs.)
CLIP_ SELECT
Select a page (or clip) defined by the value assigned to index. This may be a number specifying a
particular page or at times, another property.
For example, sending a “clip_select” command to 3Play with a suitable numeric value assigned as
the “index” key selects a specific Play List tab by index (assuming Play List mode is active. On the
other hand, in Clip List mode, if the value for “index” was “0-023” the clip referred to would be
selected.
For example:
This would select the fourth Play List tab on the 3Play output (A or B) connected to Net 1.
To Next Page
Loading...
