NI GPIB Series - Configure the GPIB-PCII;IIA Interrupt Line (IRQ) (GPIB-PCII Mode)

HOME
TitleShort-Hidden -32 © National Instruments Corporation
Configure and Install Your GPIB-PCII/IIA
Next
Step
Previous
Step
32
Configure the GPIB-PCII/IIA Interrupt Line (IRQ) (GPIB-PCII Mode)
Change the jumper settings to match the interrupt line (IRQ) assigned to your board. By default,
the GPIB-PCII/IIA is configured to use interrupt line (IRQ) 7.
If you do not know what resources were assigned to your GPIB-PCII/IIA, click here to Determine
Assigned Resources.
Table 5. GPIB-PCII Interrupt Line Configurations
Interrupt Line (IRQ) Interrupt Jumper Setting
2, 3, 4, 5, 6, 7
(IRQ 7 is shown)
No Interrupt Line (IRQ)
IRQ2
IRQ3
IRQ4
IRQ5
IRQ6
IRQ7
IRQ2
IRQ3
IRQ4
IRQ5
IRQ6
IRQ7
View Parts
Locator
Diagram