NI GPIB Series - Configure the GPIB-PCII;IIA Interrupt Line (IRQ) (GPIB-PCIIA Mode)

HOME
TitleShort-Hidden -40 © National Instruments Corporation
Configure and Install Your GPIB-PCII/IIA
Next
Step
Previous
Step
40
Configure the GPIB-PCII/IIA Interrupt Line (IRQ) (GPIB-PCIIA Mode)
Click on the interrupt line (IRQ) setting assigned to your GPIB-PCII/IIA from the list below, and
change the jumper and switch settings to match the interrupt line (IRQ) assigned to your board.
By default, the GPIB-PCII/IIA is configured to use interrupt request line IRQ 7.
If you do not know what resources were assigned to your GPIB-PCII/IIA, click here to Determine
Assigned Resources.
234
567
Interrupt Disabled