HOME
TitleShort-Hidden -57
©
National Instruments Corporation
Configure and Install Your NEC-GPIB/TNT
Next
Step
Previous
Step
57
Configure the NEC-GPIB/TNT Base I/O Address
Click on the base I/O address assigned to your NEC-GPIB/TNT from the list below, and change the
switch settings to match the base I/O address assigned to your board.
If you do not know what resources were assigned to your NEC-GPIB/TNT, click here to Determine
Assigned Resources.
1D0 2D0
3D0 4D0
5D0 6D0
7D0*
* default setting
To Next Page
Loading...
