To Next Page

To Previous Page

HOME

TitleShort-Hidden -45

National Instruments Corporation

Configure and Install Your PC/104-GPIB

Step

Configure the PC/104-GPIB Base I/O Address

Click on the base I/O address assigned to your PC/104-GPIB from the list below, and change the

switch settings to match the base I/O address assigned to your board.

If you do not know what resources were assigned to your PC/104-GPIB, click here to Determine

Assigned Resources.

100 200 300

120 220 320

140 240 340

160 260 360

180 280 380

1A0 2A0 3A0

1C0 2C0* 3C0

1E0 2E0 3E0

*default setting

Questions and Answers:

Need help?

Do you have a question about the NI GPIB Series and is the answer not in the manual?

NI GPIB Series Specifications

General

Operating Systems Supported	Windows, Linux, macOS
Driver Software	NI-488.2
Bus Interface	IEEE 488
Data Transfer Rate	Up to 8 MB/s
Compatibility	IEEE 488.1, IEEE 488.2
Connector Type	24-pin IEEE 488 connector
Maximum Cable Length	20 m total system length
Number of Devices Supported	Up to 14 devices per bus