NI GPIB Series - Configure the PC;104-GPIB Interrupt Line (IRQ)

HOME
TitleShort-Hidden -49 © National Instruments Corporation
Configure and Install Your PC/104-GPIB
Next
Step
Previous
Step
49
Configure the PC/104-GPIB Interrupt Line (IRQ)
Change the jumper settings to match the interrupt line (IRQ) assigned to your board or, if you are
installing the PC/104-GPIB in an 8-bit stack, to the line in the range IRQ3 to IRQ7 you chose on the
Resources page of the PC/104-GPIB Properties dialog box. By default, the PC/104-GPIB is
configured to use interrupt line IRQ 11.
If you do not know what resources were assigned to your PC/104-GPIB, click here to Determine
Assigned Resources.
Table 10. PC/104-GPIB Interrupt Line Configuration
Interrupt Lines Jumper Setting
Lines 10, 11, 12, or 15
(IRQ 11 is shown)
Lines 3, 4, 5, 7, or 9
(IRQ 5 is shown)
No IRQ
IRQ 10 IRQ 11
IRQ 12
IRQ 14 IRQ 15
W1
W3
IRQ 9 IRQ 7 IRQ 6
IRQ 5
IRQ 4
IRQ 3
IRQ9 IRQ7 IRQ6 IRQ5 IRQ4 IRQ3
View Parts
Locator
Diagram