HOME
TitleShort-Hidden -36
©
National Instruments Corporation
Configure and Install Your GPIB-PCII/IIA
Previous
Step
36
6. Insert the GPIB-PCII/IIA into the slot with the GPIB connector sticking out of the opening on
the back panel, as shown in Figure 6. It might be a tight fit, but do not force the board
intoplace.
Figure 6. Installing the GPIB-PCII/IIA
7. Screw the mounting bracket of the GPIB-PCII/IIA to the back panel rail of the computer.
8. Replace the top cover (or the access panel to the expansion slot).
9. Turn on your computer and start Windows.
The GPIB-PCII/IIA hardware installation is now complete.
To Next Page
Loading...
