Virtual Leased Line Services
112
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
4.4.1 Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to
configure the VLL services and provides the CLI commands.
1 Associate the service with a customer ID.
2 Define SAP parameters
Optional - associate egress and ingress filters (configured in configure>filter
context).
3 Define spoke SDP parameters.
4 Optionally configure QoS policies for the service and rate-limiting.
5 Enable the service.
4.4.2 Creating an Epipe Service
Use the following CLI syntax to create an Epipe service.
configure>service# epipe service-id [customer customer-id]
description description-string
no shutdown
The following displays an Epipe configuration example:
A:ALA-1>configure>service# info
-------------------------------------------
...
epipe 500 customer 5 create
description "ALU epipe service"
no shutdown
exit
-------------------------------------------
A:ALA-1>configure>service#
4.4.2.1 Configure Epipe QoS Attributes
Use the following CLI syntax to configure the Quality of Service attributes for the
Epipe service:
• QoS policy for ingress access side (applicable to the SAP),
• QoS policy for ingress network side and for egress network side (applicable to the
PW),
• QoS policy for self-generated traffic,
• rate limiter for egress side.
configure>service# epipe service-id [customer customer-id]
egress
rate-limit cir cir-rate pir pir-rate
To Next Page
Loading...
