Nokia 7302 - Node-ID; Rpl-Node; Table 36 Guard-Time Command; Table 37 Node-ID Command

Services Overview
96
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
Table 36 guard-time command
3.17.5.5 node-id
Table 37 node-id command
3.17.5.6 rpl-node
Table 38 rpl-node command
Item Description
Syntax guard-time time
Context configure>eth-ring
Description Configure the eth-ring guard time
Parameters time - eth-ring guard time in deciseconds
Values: 1...20
Default: 5
Item Description
Syntax node-id xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx
Context configure>eth-ring
Description Configure the node ID of the Ethernet Ring
Parameters xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx - MAC address representing the node ID.
Item Description
Syntax [no] rpl-node {owner}
Context configure>eth-ring
Description This command configures a node to act as a RPL owner in an Ethernet ring.
RPL Owner is the node connected to Ring Protection Link (RPL) that blocks traffic on RPL
during Idle state and unblocks during Protected state.
The no form of this command; removes the RPL owner functionality.
Parameters None