Nokia 7302 - Table 363 Packet-Too-Big Command; Table 364 Param-Problem Command; Packet-Too-Big

FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced Service
Issue: 13 3HH-11985-AAAA-TQZZA 391
6.10.7.12 packet-too-big
Table 363 packet-too-big command
6.10.7.13 param-problem
Table 364 param-problem command
Item Description
Syntax packet-too-big [number seconds]
no packet-too-big
Context configure>service>ies>interface>ipv6>icmp6
Description This command configures the rate for ICMP packet-too-big messages issued on the router
interface.
By default, generation of ICMP packet-too-big messages is enabled at a maximum rate of 100
per 10 second time interval.
The no form of this command disables the limiting the rate of packet-too-big on the router
interface.
Default packet-too-big 100 10
Parameters number — The maximum number of ICMP time-exceeded messages to send. This parameter
must be specified with the seconds parameter.
Values: 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP time-exceeded
messages that can be issued.
Values: 1 — 60
Item Description
Syntax param-problem [number seconds]
no param-problem
Context configure>service>ies>interface>ipv6>icmp6
Description This command configures the rate for ICMP param-problem messages issued on the router
interface.
By default, generation of ICMP param-problem messages is enabled at a maximum rate of 100
per 10 second time interval.
The no form of this command disables the limiting the rate of param-problem on the router
interface.
Default param-problem 100 10
(1 of 2)